There’s an old German saying, “If at first you cannot boat, boat and boat again. That is, two hulls are better than one.” The saying, origins unknown, applies almost too perfectly to the experience of wersy on Thingiverse. When wersy designed, printed and tested out his remote controlled motor boat, he found that his high powered plane out-runner motor was too strong. And, so, he added an extra hull.
You can see the designs for wersy’s first iteration here, and in the video above. Running on an out-runner motor for an RC plane, the boat continually capsized when the throttle was pushed too far. While some may be impressed by the design of the 3D printed RC boat, others will marvel at the doggy that barks at it without cessation.…
The original post Two Hulls Are Better Than One on 3D Printed RC Boat appeared first on 3D Printing Industry.
